UV light solid machine operating mode
Time:2016-04-14 17:42Source:sankunClick: Number
Prepared when the phone is switched on
For 30 min before the time to do a good job of the machine "5 s";
Check the machine parts are in good condition, focus on the location of the duct.
Start work
Open the master switch power supply, power supply is normal
Recovery of the emergency stop switch (if urgent stop switch);
Open the conveying system switch;
Open infrared heating (1), (2) switch, need to set temperature (generally large UV machine 50 + / - 5 ℃, small UV machine is 60 + / - 5 ℃) required for lamps. Open the weak light again after open the light. Turn it on again when the current up to 20 a UV line conveyor belt switch;
Open the UV lamp: first the weak light open, into a bright light according to the product open the lamp;
Size after UV lamp open lamp, controlled by time relay convulsions blower, will automatically open on time;
When the UV lamp (1), (2), (4), (5) the current respectively 20, 20, 20 (A) (A) (A) and 20 (A), little UV lamp (1), (2), (3) current respectively, 19, 9, 14 (A) (A) (A) said the UV lamp has fully lit.
Close the machine
Close the UV lamp (first pass light, then shut weak light);
Fire the infrared heating switch, ensure the temperature in the UV light solid machine in order to reduce;
Five minutes later turn off the cooling exhaust;
Time controller's control air supply opportunity automatically stop supply;
Switch off conveyor belt;
Shut off the main power supply, and the UV light solid machine daily check and maintenance, monthly maintenance
TAG:
UV light(45)
